HP Cartridge #63, #64, #67 Black

Refill Instructions
Black cartridge





1. Put the cartridge on some paper towels in an area where you can tolerate a spill.

2. Peel off the top label.

3. Fill the syringe with 8 ml. of black ink.

4. Very S-L-O-W-L-Y inject ink into the middle hole or the two top holes (they all go to the same sponge - only half this cartridge has a sponge - the two bottom holes are just air space and are not used - don't put any ink there).

5. When finished leave the label off or place it to where the two top holes are still exposed.

6. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/black.htm for Black

For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.

The cartridge will print just like a new one. Even though the cartridge prints good, the ink level gauge will not read full after a refill.

A Refill Kit should include Ink plus the following:
One 10cc Syringe

Quality Inks for your Printer
Printer ink and Refill kits for your Printer