HP
Cartridge #62 Color
Refill Instructions
Color cartridge
Instructions
1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel off the top label.

3. Fill the syringe with 5 ml. of color ink.
4. Very S-L-O-W-L-Y inject ink into each chamber until the
sponge is full. A little ink might come out of the top when full, so cover up the other two
holes while filling one.
5. When finished, leave
the label off or replace the top label
and push a pin into each filling hole through the label. (this is for a
vent)
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/color.htm for
Color
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
The cartridge will print just like a new one. Even though
the cartridge prints good, the ink level gauge will not read full after a refill.
A Refill Kit should include Ink plus
the following:
Three 10cc Syringes

www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer |