HP
Cartridge #62 Black
Refill Instructions
Black cartridge
Instructions
1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel off the top label.

3. Fill the syringe with
8 ml. of black ink.
4. Very S-L-O-W-L-Y inject ink into
the middle hole or the two top holes (they all go
to the same sponge - only half this cartridge has a
sponge - the two bottom holes are just air space and are not used - don't
put any ink there).
5. When finished leave
the label off or place it to where the two top holes are still exposed.
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/black.htm
for Black
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
The cartridge will print just like a new one. Even though
the cartridge prints good, the ink level gauge will not read full after a refill.
A Refill Kit should include Ink plus
the following:
One 10cc Syringe

www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer |