HP Cartridge CC656A,
#901

Refill Instructions
Color cartridge

Instructions

1. Put the cartridge on some paper towels in an area where you can tolerate a spill.

2. Peel off the top label.

3. Fill the syringe with 5 ml. of color ink.

4. Very S-L-O-W-L-Y inject ink into each chamber until the sponge is full. A little ink might come out of the top when full, so cover up the other two holes while filling one.

5. When finished, leave the label off or replace the top label and push a pin into each filling hole through the label. (this is for a vent)

6. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/color.htm for Color 

For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.

The cartridge will print just like a new one. Even though the cartridge prints good, the ink level gauge will not read full after a refill.

A Refill Kit should include Ink plus the following:
Three 10cc Syringes

Quality Inks for your Printer
www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer