HP #60 Cartridge
some of the HP #60 color cartridges they have switched the Yellow and Cyan
chambers to thwart the refilling process. So before refilling, stick a
needle into each chamber, pull the needle out and wipe with a tissue to see
what color is in what chamber.
1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel off the top label.
3. Fill the syringe with
6 ml. of color ink.
4. Very S-L-O-W-L-Y inject ink into each chamber until the
sponge full. A little ink might come out of the top when full, so cover up the other two
holes while filling one.
5. When finished leave
the top label off and the filling holes exposed (when printing it has to
pull in air).
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following page:
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.