HP #60 Cartridge
1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel off the top label.
3. Fill the syringe with
10ml of black ink for #60
or 20ml of black for #60XL
4. Very S-L-O-W-L-Y inject ink into
the center hole.
5. When finished leave
the top label off and the filling holes exposed (when printing it has to
pull in air).
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
Note: The #60 has a
smaller sponge than the #60XL
A Refill Kit should include Ink plus
One 10cc Syringe
Printer ink and Refill kits for your Printer