HP
Cartridge C9362,
#92
Refill Instructions
Black cartridge
Instructions
1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel off the top label.
3. Fill the syringe with 5 ml. of black ink.
4. Very S-L-O-W-L-Y inject ink into
the hole nearest to the copper strip. (the
other four holes are just an empty chamber).
5. When finished leave
the top label off and the filling holes exposed (when printing it has to
pull in air).
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/black.htm
for Black
If necessary leave cartridge in printer for up to 8 hours.
Note: The cartridge will print just like a new one. Even though
the cartridge prints good, the ink level gauge will not read full after a refill.
You will also notice that this cartridge didn't take much
ink. HP walled up two thirds of the cartridge so only 1/3 has a sponge with
ink and the other 2/3 is just air space. I guess they didn't want to give
you too much ink so you will buy more cartridges.
A Refill Kit should include Ink plus
the following:
One 10cc Syringe

www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer |