1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel off the top label.
3. Fill the syringe with 5 ml. of
the correct ink. (the #102 will
take 7 ml)
4. Very S-L-O-W-L-Y inject ink into each
chamber until the sponge is full. A little ink
might come out of the top when full, so cover up the other holes while
5. When finished leave
the top label off and the filling holes exposed (when printing it has to
pull in air).
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
A Refill Kit should include Ink plus
Three 10cc Syringes
Printer ink and Refill kits for your Printer