HP
Cartridge C6657,
#57 & #28
Refill Instructions
Color cartridge
Instructions
1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel off the top label.

3. Fill the syringe with 5 ml. of color ink.
4. Very S-L-O-W-L-Y inject ink into each chamber until the
sponge is full. A little ink might come out of the top when full, so cover up the other two
holes while filling one.
5. When finished leave
the top label off and the filling holes exposed (when printing it has to
pull in air).
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/color.htm for
Color
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
The cartridge will print just like a new one. Even though
the cartridge prints good, the ink level gauge will not read full after a refill. To reset
the ink level gauge back to full follow these instructions:
#57 C6657
This will allow you to reset the ID system & Ink Level Indicator built into the
printer.
RESETTING
1. Remove cartridge from your printer.
2. Place a piece of tape over the top left contact as shown in red on the picture to the
right.
3. With the tape covering the contact place cartridge back into printer.
4. The printer will perform and alignment page.
5. Once an alignment page has been printed remove cartridge from printer.
6. Place a piece of tape over the second contact shown in red.
7. Place cartridge into printer with both pieces of tape. (One covering the first contact
and one cover the second contact.)
8. Printer will print another alignment page.
9. Once the second alignment page has been printed remove cartridge from printer.
10. Remove tape pieces from cartridge contacts (Make sure there is
no residual adhesive on cartridge contacts.)
11. Place cartridge into printer. Cartridge should now read full.
Additional Notes:
As stated above it is very important that there is no residual adhesive on the cartridge
contact point. This will make reading the cartridge difficult.
If the
reset did not work on your printer, you can cycle cartridges through
to reset the level. You will need two extra cartridges and the one you
refilled. First, put the refilled cartridge in the printer. Allow it to
recognize the cartridge and print an alignment page. Take that cartridge
out and place in the first extra cartridge. Allow it to recognize and print
an alignment page. Take the first extra cartridge out and place the second
extra cartridge in. Allow it to recognize and print an alignment page.
Take the second extra cartridge out. Place the refilled cartridge back in
the printer. It will print an alignment page and then the estimated ink
level will be reset to full.
A Refill Kit should include Ink plus
the following:
Three 10cc Syringes

www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer |