1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peel the top
3. You will see a
very small vent hole in the middle of the cartridge. This hole is
too small for a needle to go through so you will have to drill the
4. Fill the syringe with
15 ml. of black ink.
5. Very S-L-O-W-L-Y inject ink into
the drilled hole.
6. When finished,
leave the label off or cut it short and put it back on being sure not to
cover up the drilled hole. This will be the cartridge's vent hole.
7. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
Note: Each time the cartridge is removed
from the printer an "empty cartridge" message appears and a blinking amber
light will come on, on the printer. Holding the paper feed (or stop/reset) button down for
3-5 sec. will allow you to override the counter.