Canon PGI-35 Black
The ink in these cartridges are retained because the cartridges have an internal
Step 1) Put the cartridges on some paper towels in an area where you can tolerate a
Step 2) Turn the cartridge up side down so that the
outlet port of the cartridge is facing upward.
Step 3) Fill the syringe with 3cc
of black ink.
Step 4) Drip ink onto the felt pad in the outlet port.
The felt pad will quickly absorb the ink into the cartridge. If the felt pad
will not soak up any more ink and the ink just sits on top then that chamber
is full. Dab a paper towel onto the felt pad to soak up any ink that did not
get absorbed into the cartridge.
Note: Do not pierce the felt pad the the needle of the syringe.
Step 5) Replace the cartridge and run 1 -
3 cleaning cycles as per printer instructions.
Or print the following page:
If necessary leave cartridge in printer for up to 4 hours
to allow the ink to saturate the entire sponge.
Note: Immediately refill any empty cartridges.
A Refill Kit should include Ink plus
One 10cc Syringe for Black with needle
Printer ink and Refill kits for your Printer