Instructions
1. Put the
cartridge on some paper towels in an area where you can tolerate a
spill.
2.
Peel off the top label.
3. You will notice
three small holes (too small for a syringe needle to get into).
Drill each hole larger with a thumb drill.
4.
Fill the syringe with 5
ml. of color ink.
5.
Very S-L-O-W-L-Y inject ink into each chamber until the
sponge full
6. When
finished,
leave the label off or cut it short and put it back on being sure not to
cover up the drilled holes. This will be the cartridge's vent holes.
7. Replace the cartridge and run 1 -
3 cleaning cycles as per printer instructions.
Or print the following page:
http://www.refillinstructions.com/color.htm
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge. (Allows
ink to flow to the print head). |