Canon Cartridge
 CL-52 (#52)

Refill Instructions for Photo cartridge

Instructions

1. Put the cartridge on some paper towels in an area where you can tolerate a spill.

2. Peel off the top label.

3. You will notice three small holes (too small for a syringe needle to get into). Drill each hole larger with a thumb drill.

4. Fill the syringe with 6 ml. of color ink.

5. Very S-L-O-W-L-Y inject ink into each chamber until the sponge full

6. When finished leave the top label off and the filling holes exposed (when printing it has to pull in air).

7. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.

For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge. (Allows ink to flow to the print head).

Note: Each time the cartridge is removed from the printer an "empty cartridge" message appears and a blinking amber light will come on, on the printer. Holding the paper feed (or stop/reset) button down for 3-5 sec. will allow you to override the counter.

A Refill Kit should include Ink plus the following:
Thumb Drill
Three 10cc Syringes with sharp needle

Quality Inks for your Printer
www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer